Setting up your development environment

If you don't have Node.JS already installed, you can download an installer for your platform from nodejs.org. This installer will also install NPM or Node Package Manager, which will be used to manage the rest of the software that we'll be using.

Run the installer on your machine, which may require a restart. After this, open up your terminal application and run the following command:

node –-version

The output from this command should be 4.x.x, where x are integers.

In your terminal, create a folder for your project and change directories to this folder:

mkdir my-robotics-project
cd my-robotics-project

Next, we're going to install Johnny-Five:

npm install johnny-five

You should see a spinner, followed by some output. Unless you see an ERR NOT OK message at the end of your output, you're good to go with Johnny-Five.

First, you should get the Arduino IDE. Yes, we are still using JavaScript; however, we must make sure that there's a particular sketch (that's Arduino-speak for program) running on our board in order for Johnny-Five to communicate properly.

You can get the installer at the Arduino website (http://www.arduino.cc/en/Main/Software). This book assumes that you have version 1.6.4, but the versions in the 1.4 range should work as well.

Once you've downloaded the software, open it. Then, we'll make sure that your serial connection works.

Plug the USB cable into both the board and the computer. A few LEDs should light up on this board—this is normal. Then, go to the Tools menu in the Arduino IDE and hover over the ports submenu. You should see a list of ports that looks somewhat like the following screenshot:

You should see at least one entry in this list that fits the following format: /dev/cu.usbmodem*****. It may or may not have Arduino Uno next to it. If you see this, go ahead and click on it, because this is the port you will want to use for the Firmata installation. If you have this, it means your board can communicate with your computer, and you're ready to install Firmata.

To install Firmata on your board, go to File | Examples | Firmata | StandardFirmata, as shown in the following screenshot:

Once you've opened the sketch, you should get an IDE window that looks like the following screenshot:

Once this sketch is up, click on the Upload button (it looks like an arrow pointing to the right) to upload Firmata to your board. Once the uploading is done, you can close the Arduino IDE, and you will be ready to start working with JavaScript.